LED Strip Holder_001

Category:Core P5
File Size: 0.31MB
  • 3hr18min

    Print Time

  • 5


  • 2


  • 117


This little holder is designed to hold LED strips around and against the acrylic panel of Core P5, to provide an Illuminated effect on the Core P5.

Copyright Notice

This website and its content is copyright of Thermaltake Technology Co., Ltd. - © Thermaltake 2016. All rights reserved.

Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

• You may print or download to a local hard disk extracts for your personal and non-commercial use only.

• You may copy the content to individual third parties for their personal use, but only if you acknowledge the website as the source of the material.

• You may not, except with our express written permission, distribute or commercially exploit the content. Nor may you transmit it or store it in any other website or other form of electronic retrieval system.

Limitation of Liability Clause

Thermaltake Technology Co., Ltd. has no control over the conduct of Hubs and Users, the 3D Prints and services provided by Hubs, the storage or handling or any future use of the 3D Model by a Hub, and Thermaltake Technology Co., Ltd. disclaims any and all liability in this regard.

Thermaltake Technology Co., Ltd. shall not be liable, except for gross negligence and wilful misconduct, for damages, direct or indirect, arising from, but not exclusively, 3D print files, the printing process, or the products. Neither party shall be liable, except for illegal and wilful misconduct for any special, indirect, incidental, punitive, exemplary or consequential damages including, but not limited to, lost profits, even if the other party has been advised of the possibility of such damages.


Take a picture of your 3D model, upload it to our Gallery, and share your model with your fellow Makers. Have fun sharing!

Comments(2 )

  • Prakash Patel
    2016/6/5 上午 06:00:11
    I do have a request, Would it be possible for you to make a rear I/O Shield Bracket. Thanks
  • Brennon Baxter
    2016/2/10 上午 07:45:06
    File will not download. Link is another page with a link, and it will not download. Please Fix.
  • 100 Characters Left

Copyright © 2016 Thermaltake Technology Co., Ltd. All Rights Reserved.