Radiator Holder_001

Category:Core P Series
File Size: 1.89MB
  • 4hr00min

    Print Time

  • 8


  • 5


  • 657


The radiator holder is designed to be attached to the case panel and fits radiator sizes in 120mm/140mm bases. It allows users to mount their radiator perpendicular to the case panel. For different presentation it could also be paired with Radiator Holder_004.

Copyright Notice

This website and its content is copyright of Thermaltake Technology Co., Ltd. - © Thermaltake 2016. All rights reserved.

Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

• You may print or download to a local hard disk extracts for your personal and non-commercial use only.

• You may copy the content to individual third parties for their personal use, but only if you acknowledge the website as the source of the material.

• You may not, except with our express written permission, distribute or commercially exploit the content. Nor may you transmit it or store it in any other website or other form of electronic retrieval system.

Limitation of Liability Clause

Thermaltake Technology Co., Ltd. has no control over the conduct of Hubs and Users, the 3D Prints and services provided by Hubs, the storage or handling or any future use of the 3D Model by a Hub, and Thermaltake Technology Co., Ltd. disclaims any and all liability in this regard.

Thermaltake Technology Co., Ltd. shall not be liable, except for gross negligence and wilful misconduct, for damages, direct or indirect, arising from, but not exclusively, 3D print files, the printing process, or the products. Neither party shall be liable, except for illegal and wilful misconduct for any special, indirect, incidental, punitive, exemplary or consequential damages including, but not limited to, lost profits, even if the other party has been advised of the possibility of such damages.


Take a picture of your 3D model, upload it to our Gallery, and share your model with your fellow Makers. Have fun sharing!

Comments(5 )

  • Ian Sterling
    5/5/2021 4:05:00 PM
    FYI, the STL provided only had holes for 140mm rads; I needed to drill another for my 120mm rad.
  • Ian Sterling
    5/5/2021 4:03:54 PM
    Mike: I printed 2 at a time on a 235x235 bed with lots of room to spare.
  • Mike A
    9/15/2020 7:22:04 PM
    What size bed do I need to print this ?
  • Rafael Post
    2/29/2020 5:44:44 PM
    for push/pull you wil need a longer screw
  • Jason Van Dyke
    3/17/2018 9:49:45 PM
    Has anyone tried push/pull setup with these? Will fans fit on the bracket side? Work on 480mm rad?
  • 100 Characters Left

Copyright © 2016 Thermaltake Technology Co., Ltd. All Rights Reserved.