Fan Bracket_002

Category:Core P Series
File Size: 1.87MB
  • 5hr0min

    Print Time

  • 15


  • 6


  • 1147


A fan bracket is designed hook onto the metal pillar of Core P3/P5/P7 and to be compatible with 120mm and 140mm fan installtion.

Copyright Notice

This website and its content is copyright of Thermaltake Technology Co., Ltd. - © Thermaltake 2016. All rights reserved.

Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

• You may print or download to a local hard disk extracts for your personal and non-commercial use only.

• You may copy the content to individual third parties for their personal use, but only if you acknowledge the website as the source of the material.

• You may not, except with our express written permission, distribute or commercially exploit the content. Nor may you transmit it or store it in any other website or other form of electronic retrieval system.

Limitation of Liability Clause

Thermaltake Technology Co., Ltd. has no control over the conduct of Hubs and Users, the 3D Prints and services provided by Hubs, the storage or handling or any future use of the 3D Model by a Hub, and Thermaltake Technology Co., Ltd. disclaims any and all liability in this regard.

Thermaltake Technology Co., Ltd. shall not be liable, except for gross negligence and wilful misconduct, for damages, direct or indirect, arising from, but not exclusively, 3D print files, the printing process, or the products. Neither party shall be liable, except for illegal and wilful misconduct for any special, indirect, incidental, punitive, exemplary or consequential damages including, but not limited to, lost profits, even if the other party has been advised of the possibility of such damages.


Take a picture of your 3D model, upload it to our Gallery, and share your model with your fellow Makers. Have fun sharing!

Comments(6 )

  • John Babatsikos
    1/17/2018 11:24:08 PM
    Is it possible to make a triple 140 fan version to slide into top and bottom metal pillars on right
  • Michael Warchut
    6/23/2017 9:59:36 PM
    Worked Great.... Thanks..
  • david pickering
    8/10/2016 11:23:33 PM
    hi will this fit the core p3 ?
  • Prakash Patel
    6/5/2016 5:58:49 AM
    I do have a request, Would it be possible for you to make a rear I/O Shield Bracket. Thanks
  • David Todua
    5/17/2016 5:14:02 PM
    this one couldnt be printed, because most part is in the air.pls, repair
  • John Thorn
    2/6/2016 2:49:01 AM
    Dosent work? wrong files!
  • 100 Characters Left

Copyright © 2016 Thermaltake Technology Co., Ltd. All Rights Reserved.